NexStarCtl
===========

This module implements the serial commands supported by the Celestron 
NexStar hand control. This applies to the NexStar GPS, NexStar GPS-SA, 
NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX,
Advanced-GT, and CGE mounts.

Communication to the hand control is 9600 bits/sec, no parity and one 
stop bit via the RS-232 port on the base of the hand control.

INSTALLATION

To install this module type the following:

   perl Makefile.PL
   make
   make test
   make install

DEPENDENCIES

   Device::SerialPort
   Time::Local

COPYRIGHT AND LICENCE

Copyright (C) 2013-2014 by Rumen G.Bogdanovski

This library is free software; you can redistribute it and/or modify
it under the same terms as Perl itself, either Perl version 5.12.4 or,
at your option, any later version of Perl 5 you may have available.

The author assumes no liability or responsibility for damage or injury
to persons or property arising from any use of this product. Use it at
your own risk.